Single bar vibrating material level switch is one of the tuning fork material level switch, it is not afraid of hanging material is not afraid of impact, no clamping problem, and more sensitive. Its cylindrical, single rod structure determines its wider adaptability to industrial sites. The single-bar vibrating material level switch uses the "resonance" principle of tuning fork to produce vibration under the drive of piezoelectric element. Only when the rod is surrounded by all materials, the vibration amplitude will be sharply reduced, thus producing switching action.

One, single bar vibration type material level switch characteristics:

1, Round smooth single rod probe, can effectively prevent clamping and sticky material;

2. It is not affected by the properties of the measured substance and installation conditions, and can be put into use stably without adjustment after installation;

3. The piezoelectric element is embedded in the rod body and the thick tube wall of the stainless steel probe, vibration suppression tube is only 9mm long (similar ratio is short), high stable vibration, heavy load resistance, long life;

4. Depending on the nature and specific gravity of the object to be measured, the sensitivity (high, medium, low) can be selected;

5, Use 15A large capacity contact relay switch, can directly control the motor;

II. Main technical parameters:

Power supply: 220V / 105V, AC50/60Hz

Power consumption: 2VA

Contact capacity: 250V 10A AC, 30V 5A DC

Vibration frequency: 280Hz

Delay time: 0.5 seconds when measured (vibration to stop), 1 ~ 2 seconds when demobilized (vibration to stop)

Working temperature: probe part -30 degrees ~ 150 degrees, substrate part -30 ~ 70 degrees

Resistance to pressure (MAX) : 20KGF/CM2 (1960kPa)

Probe front load: 100KGF (MAX)

Material: probe 0Cr18Ni9 (SUS304) chassis, ADC (surface spray)

Switch function: normally open, normally closed, common

Probe length: standard 189mm/extended 250 ~ 50000mm

Thread interface: 1 inch, 1.5 inch, etc

Weight: 2.5 KG

Three, single bar vibration type material level switch

1, liquid: petroleum, all kinds of fuels, acid, alcohol, all kinds of beverages, beer, liquefied gas, pure water, etc

2. Mixed liquid: factory waste liquid, urban drainage, pesticide, industrial products, all kinds of aqueous solution, etc

3, interface: crude oil and water, mercury in water, alcohol and acid water precipitate liquid and bubble

4, instant noodles: beer bubble, soap bubble

5, adhesive: all kinds of coatings, adhesives, all kinds of resin, cleaning agent, molasses, all kinds of slurry agent, etc

6, powder body: cement, lime, iron powder, fertilizer, washing powder, refined salt, refined sugar, flour, milk powder, etc

7, granular body: chemical raw materials, drugs, food, etc

8, block: coal, limestone, ore and so on.